SILICON BASED WATER REPELLENT COATING FOR STONE, BRICK AND CONCRETE SURFACES

Glossy 1001 Weathergold 2000 Pro is composed of Siloxane & Silane polymers dispersed in high boiling point solvent. It is used for water proofing of concrete & cementitious vertical walls of building because it penetrates deeply into the substrate & provides an effective water repellent protective costing. It does not change the appearance of the substrate & the water repellent coating is UV resistant and durable.

Areas of Application

• Water proofing treatment for –
• Cement painted surfaces
• Concrete, mortar
• Clay brick surfaces
• Natural and artificial stones: Marble, Dholpur, Sand Stone, All Porous Stone
• Mangalore tiled roofs
• Corrugated AC sheet roofing, etc

Features & Benefits

• Ease of application-Ready to use, simply brushable or spray applied.
• Staining-Clear coating does not stain the treated surface.
• Appearance-Does not change the appearance of exterior decorative coating.
• Vapour transmission – Prevents entry of moisture into the wall, but allows moisture to evaporate out
• Efflorescence – Prevents efflorescence
• Economical-Cost effective
• Penetration – Due to low viscosity, penetration is high, which provides the hydrophobic zone.

SURFACE PREPARATION

• Surface should be dry and free from all debris, dirt, oil, grease, wax and all other contamination, which could prevent penetration.
• Clean the saturated dirt of surface by thorough wire brushing, cleaning with compressed air followed by water washing.
• Decrease oil & grease by using solvents like turpentine or thinners.
• Allow the surface to dry completely before the application.
• Seal the cracks with GLOSSY FILLING POWDER
• Thorough wire brushing followed by sanding with emery paper is recommended.
• Remove the existing paint, Nero or instant lime, etc, while treating internal damp walls.

APPLICATION

• Apply one liberal coat of Glossy Weathergold 2000 Pro, simply by brushing evenly on the prepared surface.
• Allow the surface to dry for a minimum of 24 hrs for best results.
• Glossy Weathergold 2000 Pro can also be applied with an airless spray (0.07-0.1 N/mm2 pressure).
• Apply second coat wet on wet to improve the penetration rate & performance.
• Allow it to dry for 24 hrs.

Precautions

• Do not dilute with water or by any other means.
• Close the container lid properly after use.
• Before applying over the natural stones like sand stone or Dholpur, sampling should be done on a small area to check its suitability.
• Before taking up application on a large area, it is advisable to check the performance of the product on a relatively small area.

Coverage

On porous substrate-               5-6 Sq meter/litre

On Low porous substrate-      7-8 Sq meter/litre

Shelf Life & Storage

Shelf life is 12 months from the date of manufacturing in unopened condition

Store in a cool & dry place:

Health & Safety Precautions

Use rubber hand gloves & safety goggles, while using Glossy Weathergold 2000 Pro

Keep out of reach of children.

In case of contact with skin, wash with plenty of water.

Do not smoke during application.