INSTRUCTIONS FOR USE OF HARDCOTE  SILICONE ALUMINUM PAINT

HARDCOTE HT 400 – FOR 250°C TO 400°C Dry Heat Resistant

HARDCOTE HT 600 – FOR 400°C TO 600°C Dry Heat Resistant

HARDCOTE is a heat resistant aluminum paint based on silicon resin medium designed for protection of steel at elevated temperature. It is used for protection of stacks, kilns exhaust system, incinerators etc.

SURFACE PREPARATION : Surface to be coated with HARDCOTE should be thoroughly clean and free of rust, scale. Dirt, oil and grease and other contaminants. Surface must be dry and cool.

APPLICATION : Stir thoroughly before and occasionally during use. For initial application two or three coats are required by conventional spray or brush. For brush application use a flat brush only. Avoid repeated brush strokes bor better luster. Generally no thinner is required for brush application. For spray application, thinner upto 5% may be required.

CURING : Apply 1^st coat. Air dry for 24 hours. Alternatively heat cure at 200°C for 1 hour after 4 hours of air drying. Apply 2^nd and 3^rd coat similarly. Allow the system to dry overnight and then slowly raise the temperature to working temperature (initial increase upto 200°C over a 6 hours time period)

THINNER : Use GLOSSY HT Thinner for best results.

WARNING :

Check actual skin temperature before selecting these products. It dose not cure and remains for until heated at minimum 200°C for one hour. Painted component should not be handled without heat curing.

In confined spaces provide adequate ventilation during application and drying. This is also essential for health and safety of the painter.

The fumes given off can be dangerous. Provision laid in factory and boilers act must be adhered to, including the use of flamefroof light, forced drought ventilation and safety lines.

Avoid applying thick coat since that may cause blistering/delaminating.

Please refer to separate technical data sheet and safety data sheet available on request. If in doubt regarding suitability of use of these products, please consult Glossy industrial Paints division.

Description :

Thinning :

Uses :

Finish :

Application :

Covering Capacity :

Drying Time :

Color Range :

Packing :

Highlights :

Shelf Life :

Undercoats :

Application Areas :